# Changelog

## v0.1.0

This is a preliminary release based on TI's board support package 09.02.00.010.
The hardware boots Nerves and some of the peripherals are available. If using
GPIO, refer to the schematic `PROC142(A002)_SCH_With_Design_Updates..Notes_V1.0.pdf`
in SK-AM62B-P1 Design Package File [spar001a.zip](https://www.ti.com/lit/zip/spar001). The signal names on the
schematic can be used to configure the GPIO, as these are not exported to sysfs.

SPI does not seem to work even though it appears to be configured in the
device tree.

- Supported hardware
   - TI [SK-AM62B-P1](https://www.ti.com/tool/SK-AM62B-P1)

- Validated peripherals
   - UART5
   - I2C0, I2C2
   - GPIO (use [circuits_gpio v2](https://hex.pm/packages/circuits_gpio))
   - ETH0, ETH1
   - Heartbeat LED
   - OSPI flash
   - Board ID EEPROM
   - CPU & memory temperature sensors
   - User header load switches

- Dependencies
   - TI BSP 09.02.00.010
   - [Erlang/OTP 26.2.5](https://erlang.org/download/OTP-26.2.5.README)
   - [Buildroot 2024.02.2](https://lore.kernel.org/buildroot/874jbaxb7g.fsf@dell.be.48ers.dk/)